No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - Device Management

S9300, S9300E, and S9300X V200R012C00

This document describes the configurations of Device Management, including device status query, hardware management, CSS, SVF, PoE, OPS, OIDS, energy-saving management, information center, fault management, NTP, synchronous ethernet, PTP.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Setting the ALS Pulse Interval and Width of the Laser

Setting the ALS Pulse Interval and Width of the Laser

Context

The ALS pulse interval indicates the time between two consecutive pulse transmissions and applies to the automatic restart mode. The ALS pulse width indicates the pulse period and applies to the automatic restart mode and manual restart mode.

  • In automatic restart mode, a small pulse width and a long pulse interval save more energy but cannot ensure that optical link recovery can be detected in a timely manner.

  • In manual restart mode, a small ALS pulse width saves energy but cannot ensure that optical link recovery can be detected in a timely manner. In contrary, a large ALS pulse width ensures that optical link recovery can be detected in a timely manner but wastes energy.

You can set a proper laser pulse interval and width to ensure energy conservation and timely detection of optical link recovery.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run interface interface-type interface-number

    The interface view is displayed.

  3. Run als restart pulse-interval pulse-interval

    The ALS pulse interval of the laser is set.

    By default, the ALS pulse interval is 100s.

  4. Run als restart pulse-width pulse-width

    The ALS pulse width of the laser is set.

    By default, the ALS pulse width is 2s.

Translation
Download
Updated: 2018-09-03

Document ID: EDOC1100038289

Views: 39241

Downloads: 15

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next