No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - Device Management

S9300, S9300E, and S9300X V200R012C00

This document describes the configurations of Device Management, including device status query, hardware management, CSS, SVF, PoE, OPS, OIDS, energy-saving management, information center, fault management, NTP, synchronous ethernet, PTP.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring the Device to Output Traps to the Trap Buffer

Configuring the Device to Output Traps to the Trap Buffer

Context

To view traps in the trap buffer, configure the device to output traps to the trap buffer.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run info-center trapbuffer

    The device is enabled to output traps to the trap buffer.

    By default, the device is enabled to output traps to the trap buffer.

  3. Run info-center trapbuffer channel { channel-number | channel-name }

    The channel used by the device to output traps to the trap buffer is specified.

    By default, the device uses channel 3 to output traps to the trap buffer.

  4. Run info-center source { module-name | default } channel { channel-number | channel-name } trap { state { off | on } | level severity } *

    A rule for outputting traps to a channel is set.

    By default, channel 3 is enabled to output traps and the lowest severity is debugging.

  5. (Optional) Run info-center trapbuffer size trapbuffer-size

    The maximum number of traps in the trap buffer is set.

    By default, the trap buffer can store a maximum of 256 traps.

Translation
Download
Updated: 2018-09-03

Document ID: EDOC1100038289

Views: 43015

Downloads: 15

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next