No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - Device Management

S9300, S9300E, and S9300X V200R012C00

This document describes the configurations of Device Management, including device status query, hardware management, CSS, SVF, PoE, OPS, OIDS, energy-saving management, information center, fault management, NTP, synchronous ethernet, PTP.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Setting the WTR Time of a Clock Source

Setting the WTR Time of a Clock Source

Context

Setting the WTR time of a clock source can avoid some mistakes in determining the clock source caused by occasional signal jitter on the network. The default WTR time of a clock source is 1 minute. Generally, you do not need to change the default value. If you want to see the clock source switching result during debugging, set the WTR time to 0.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run clock wtr wtr-time

    The wait-to-restore (WTR) time of a clock source is set.

    By default, the WTR time of a clock source is 1 minute.

Translation
Download
Updated: 2018-09-03

Document ID: EDOC1100038289

Views: 42177

Downloads: 15

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next