No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Configuration Guide - Device Management

S9300, S9300E, and S9300X V200R012C00

This document describes the configurations of Device Management, including device status query, hardware management, CSS, SVF, PoE, OPS, OIDS, energy-saving management, information center, fault management, NTP, synchronous ethernet, PTP.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Application Scenarios for PTP

Application Scenarios for PTP

PTP Application on a Transmission Network

Most of the time-division multiplexing (TDM) service on a traditional fixed network is the voice service. If the clocks on two ends of the transmission network are different, the accumulated difference between the clocks will cause clock slip. In Figure 13-11, an ordinary clock (OC) device encapsulates high-precision clock information obtained through the GPS into a PTP message and sends the PTP message to a boundary clock (BC) device on the transmission network. Core devices on the transmission network function as transparent clock (TC) devices to transparently transmit the clock information to the entire transmission network. Then the edge devices of the transmission network function as BC devices to provide the high-precision clock information obtained through the PTP message to wireless access devices, such as NodeB and radio network controller (RNC).

Figure 13-11  Application of PTP on a transmission network

Network Protection

PTP supports protective switchover between devices and between components on the same device to prevent single-point failures. In Figure 13-12, the solid lines identify the primary clock tracing path. The time source is provided by GPS-1 and is transmitted to the lower layers in the direction shown by the blue arrows. The dashed lines identify the protection path. When the primary path is faulty, GPS-2 can replace GPS-1 to provide the time source rapidly.

Figure 13-12  Protective switchover on the time synchronization network

Updated: 2018-09-03

Document ID: EDOC1100038289

Views: 42987

Downloads: 15

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Previous Next