No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

S9300, S9300E, and S9300X V200R012C00 Configuration Guide - Ethernet Switching

This document describes the configuration of Ethernet services, including configuring MAC address table, link aggregation, VLANs, VLAN aggregation, MUX VLAN, VLAN termination, Voice VLAN, VLAN mapping, QinQ, GVRP, STP/RSTP/MSTP, VBST, SEP, RRPP, ERPS, LBDT, HVRP, and Layer 2 protocol transparent transmission.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring the Switch to Advertise Voice VLAN Information to an IP Phone

Configuring the Switch to Advertise Voice VLAN Information to an IP Phone

Context

Generally, IP phones that can send tagged voice packets can obtain voice VLAN information from the switch using a protocol such as LLDP (LLDP is used as an example). LLDP needs to be enabled. When the switch receives an LLDPDU from an IP phone, the switch encapsulates voice VLAN information in the LLDPDU and sends it to the IP phone. The IP phone then sends tagged voice packets.

The switch can encapsulate voice VLAN information into LLDPDUs and send them to connected IP phones. However, IP phones of some vendors send Cisco Discovery Protocol (CDP) packets. You can run the voice-vlan legacy enable command to enable CDP-compatible function so that the switch encapsulates voice VLAN information in CDP packets and sends them to connected IP phones.

Procedure

  • Configuring the switch to advertise voice VLAN information to an IP phone through LLDP
    1. Run system-view

      The system view is displayed.

    2. Run lldp enable

      LLDP is enabled globally.

      By default, LLDP is enabled globally.

    3. Run interface interface-type interface-number

      The interface view is displayed.

    4. Run lldp enable

      LLDP is enabled on the interface.

      After LLDP is enabled in the system view, all interfaces are enabled with LLDP.

  • Configuring Cisco Discovery Protocol (CDP)-compatible Voice VLAN function
    1. Run system-view

      The system view is displayed.

    2. Run interface interface-type interface-number

      The interface view is displayed.

    3. Run voice-vlan legacy enable

      CDP-compatible Voice VLAN function is enabled so that the switch encapsulates voice VLAN information in CDP packets and sends them to the IP phone.

      By default, CDP-compatible Voice VLAN function is disabled.

Translation
Download
Updated: 2019-01-18

Document ID: EDOC1100038290

Views: 105461

Downloads: 24

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next