No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

S9300, S9300E, and S9300X V200R012C00 Configuration Guide - Ethernet Switching

This document describes the configuration of Ethernet services, including configuring MAC address table, link aggregation, VLANs, VLAN aggregation, MUX VLAN, VLAN termination, Voice VLAN, VLAN mapping, QinQ, GVRP, STP/RSTP/MSTP, VBST, SEP, RRPP, ERPS, LBDT, HVRP, and Layer 2 protocol transparent transmission.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Creating an Instance

Creating an Instance

Context

You can map data in VLANs to an instance and configure the instance to the protected VLAN so that the device can control data in VLANs based on RRPP.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run stp region-configuration

    The MST region view is displayed.

  3. Run instance instance-id vlan { vlan-id1 [ to vlan-id2 ] }&<1-10>

    The mapping between the instance and VLAN is configured.

    instance-id in this command must be the same as instance-id used by the protected-instance command.

    NOTE:

    The control VLANs of the major ring and the sub-rings must be contained in the VLAN list.

    To configure the mapping between the instance and MUX VLAN, you are advised to configure the principal VLAN, and subordinate group VLANs and subordinate separate VLANs of the MUX VLAN in the same instance. Otherwise, loops may occur.

    If the stp mode (system view) command is used to configure the switch to work in VBST mode, the static instance protected by RRPP cannot be directly deleted.

    Instance 0 is the default instance and does not need to be created.

    By default, all VLANs are mapped to Instance 0.

  4. Run active region-configuration

    The configuration of the MST domain is activated.

Translation
Download
Updated: 2019-01-18

Document ID: EDOC1100038290

Views: 99966

Downloads: 24

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next