No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

S9300, S9300E, and S9300X V200R012C00 Configuration Guide - Ethernet Switching

This document describes the configuration of Ethernet services, including configuring MAC address table, link aggregation, VLANs, VLAN aggregation, MUX VLAN, VLAN termination, Voice VLAN, VLAN mapping, QinQ, GVRP, STP/RSTP/MSTP, VBST, SEP, RRPP, ERPS, LBDT, HVRP, and Layer 2 protocol transparent transmission.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
A Switch Connects to a Server

A Switch Connects to a Server

As shown in Figure 3-16, to improve the server bandwidth and reliability, two or more network adapters of the server are aggregated to form a network adapter group to implement load balancing or redundancy.

In addition to the configuration notes in Licensing Requirements and Limitations for Link Aggregation, be aware of the following points:

  • Network adapters of the server must be of the same type.
  • The link aggregation modes on the server and access device must be consistent.

    For example, if an Intel network adapter is used, a server often uses static or IEEE 802.3ad dynamic link aggregation. When the server uses static link aggregation, the access device must use the manual mode. When the server uses IEEE 802.3ad dynamic link aggregation, the access device must use the LACP mode.

  • When a server needs to obtain the configuration file from the remote file server through a switch and link aggregation needs to be used, run the lacp force-forward command on the Eth—Trunk of the switch.
NOTE:

Different types of network adapters use different link aggregation configurations. For details, refer to the network adapter operation guide.

Figure 3-16  Switch connects to a server
Translation
Download
Updated: 2019-01-18

Document ID: EDOC1100038290

Views: 101293

Downloads: 24

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next