No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


S9300, S9300E, and S9300X V200R012C00 Configuration Guide - Ethernet Switching

This document describes the configuration of Ethernet services, including configuring MAC address table, link aggregation, VLANs, VLAN aggregation, MUX VLAN, VLAN termination, Voice VLAN, VLAN mapping, QinQ, GVRP, STP/RSTP/MSTP, VBST, SEP, RRPP, ERPS, LBDT, HVRP, and Layer 2 protocol transparent transmission.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Verifying the Basic VBST Configuration

Verifying the Basic VBST Configuration


  • Run the display stp [ vlan vlan-id ] [ interface interface-type interface-number | slot slot-id ] [ brief ] command to check the spanning tree status and statistics.
  • Run the display stp [ vlan vlan-id ] active command to check details of and statistics on spanning trees of all ports in Up state.
  • Run the display stp [ vlan vlan-id ] bridge { root | local } command to check the spanning tree status of the local bridge and root bridge.
  • Run the display stp global command to check the summary of the spanning tree protocol.
  • Run the display stp region-configuration [ digest ] command to check the mapping between instances and VLANs.
Updated: 2019-01-18

Document ID: EDOC1100038290

Views: 110738

Downloads: 24

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Previous Next