No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


S9300, S9300E, and S9300X V200R012C00 Configuration Guide - Ethernet Switching

This document describes the configuration of Ethernet services, including configuring MAC address table, link aggregation, VLANs, VLAN aggregation, MUX VLAN, VLAN termination, Voice VLAN, VLAN mapping, QinQ, GVRP, STP/RSTP/MSTP, VBST, SEP, RRPP, ERPS, LBDT, HVRP, and Layer 2 protocol transparent transmission.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
(Optional) Configuring Permanent VLANs

(Optional) Configuring Permanent VLANs


A permanent VLAN is never aged by an HVRP interface. If an HVRP interface does not receive any registration packets from a VLAN within the aging time, the VLAN is deleted from the HVRP interface. If dedicated services are configured for some VLANs (for example, mVLAN) and the VLANs do not need to be aged, you can configure the VLANs as permanent VLANs.


  1. Run system-view

    The system view is displayed.

  2. Run hvrp permanent-vlan { vlan-id1 [ to vlan-id2 ] }&<1-10>

    The VLAN is configured as a permanent VLAN.

    By default, no VLAN is a permanent VLAN.

    You can configure a VLAN as a permanent VLAN only after the VLAN is created.

Updated: 2019-01-18

Document ID: EDOC1100038290

Views: 102806

Downloads: 24

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Previous Next