No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


S9300, S9300E, and S9300X V200R012C00 Configuration Guide - Ethernet Switching

This document describes the configuration of Ethernet services, including configuring MAC address table, link aggregation, VLANs, VLAN aggregation, MUX VLAN, VLAN termination, Voice VLAN, VLAN mapping, QinQ, GVRP, STP/RSTP/MSTP, VBST, SEP, RRPP, ERPS, LBDT, HVRP, and Layer 2 protocol transparent transmission.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
What Are Precautions for Configuring the Formats of Sent and Received BPDUs on an STP Interface?

What Are Precautions for Configuring the Formats of Sent and Received BPDUs on an STP Interface?

When a Huawei switch is connected to another vendor' device, the two devices may fail to communicate because of different keys in BPDUs even though they have the same domain name, revision level, and VLAN mapping table. To solve this problem, run the stp config-digest-snoop command to enable digest snooping. This function enables the Huawei switch to keep its BPDU key consistent with that used on the peer device.

Updated: 2019-01-18

Document ID: EDOC1100038290

Views: 113044

Downloads: 24

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Previous Next