No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

S9300, S9300E, and S9300X V200R012C00 Configuration Guide - Ethernet Switching

This document describes the configuration of Ethernet services, including configuring MAC address table, link aggregation, VLANs, VLAN aggregation, MUX VLAN, VLAN termination, Voice VLAN, VLAN mapping, QinQ, GVRP, STP/RSTP/MSTP, VBST, SEP, RRPP, ERPS, LBDT, HVRP, and Layer 2 protocol transparent transmission.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Adding a Port to an MSTP Process

Adding a Port to an MSTP Process

Context

After being added to MSTP processes, interfaces can participate in MSTP calculation. The links connecting MSTP-enabled devices and access rings are called access links, and the link shared by multiple access rings is called a shared link. Interfaces on this shared link participate in MSTP calculation in multiple access rings and MSTP processes.

Procedure

  • Adding a port on an access link to an MSTP process
    1. Run system-view

      The system view is displayed.

    2. Run interface interface-type interface-number

      The Ethernet interface view is displayed.

      The interface specified in this command must be the interface that connects the device and the access ring.

    3. Run stp binding process process-id

      The port is added to the specified MSTP process.

      NOTE:

      If an interface joining the MSTP process has sub-interfaces configured with other features such as VPLS, run the stp vpls-subinterface enable command. The main interface can then notify its sub-interfaces to update MAC address entries and ARP entries after receiving a TC-BPDU. This prevents service interruption. In addition, root protection needs to be configured on the main interface. Switch XGE interfaces connected to the LE1D2FW00S01 card do not support the notification function.

      A port on an access link can join only one MSTP process. If you run this command multiple times, only the latest configuration takes effect.

  • Adding a port on a shared link to an MSTP process
    1. Run system-view

      The system view is displayed.

    2. Run interface interface-type interface-number

      The view of the Ethernet interface that participates in spanning tree calculation is displayed.

      The interface specified in this command must be an interface on the shared link between the devices configured with MSTP multi-process. It cannot be an interface that connects an access ring and device.

    3. Run stp binding process process-id1 [ to process-id2 ] link-share

      The port is added to multiple MSTP processes to complete MSTP calculation.

      NOTE:

      In an MSTP process where there are multiple shared links, run the stp enable command in the MSTP multi-instance view. On an interface that is added to an MSTP process, run the stp enable command in the interface view.

Translation
Download
Updated: 2019-01-18

Document ID: EDOC1100038290

Views: 101238

Downloads: 24

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next