No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

S9300, S9300E, and S9300X V200R012C00 Configuration Guide - Ethernet Switching

This document describes the configuration of Ethernet services, including configuring MAC address table, link aggregation, VLANs, VLAN aggregation, MUX VLAN, VLAN termination, Voice VLAN, VLAN mapping, QinQ, GVRP, STP/RSTP/MSTP, VBST, SEP, RRPP, ERPS, LBDT, HVRP, and Layer 2 protocol transparent transmission.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Overview of VLAN Mapping

Overview of VLAN Mapping

Definition

VLAN mapping technology changes VLAN tags in packets to map different VLANs.

Purpose

Two Layer 2 user networks in the same VLAN can be connected through a backbone network. To ensure Layer 2 connectivity between users, and to uniformly deploy Layer 2 protocols, the two user networks need to interwork seamlessly. However, the backbone network cannot directly transmit VLAN packets from the user networks, because the VLAN plans on the backbone and user networks are different.

To solve this problem, configure VLAN mapping. When VLAN packets from a user network enter the backbone network, an edge device on the backbone network changes the customer VLAN (C-VLAN) ID to the service VLAN (S-VLAN ID). After the packets are transmitted, the edge device reverts the VLAN ID change. This ensures seamless interworking between the two user networks. The other method is to configure a Layer 2 tunneling technology such as QinQ or VPLS to encapsulate VLAN packets into packets on the backbone network so that VLAN packets are transparently transmitted. However, this method increases extra cost because packets are encapsulated. In addition, Layer 2 tunneling technology may not support transparent transmission of packets of some protocol packets. The other method is to configure VLAN mapping. When VLAN packets from a user network enter the backbone network, an edge device on the backbone network changes the C-VLAN ID to the S-VLAN ID. After the packets are transmitted to the other side, the edge device changes the S-VLAN ID to the C-VLAN ID. This method implements seamless interworking between two user networks.

Configuring VLAN mapping on the switch connecting the two user networks allows a user to manage the two networks as a single Layer 2 network, despite the differing VLAN plans of the user networks.

Translation
Download
Updated: 2019-01-18

Document ID: EDOC1100038290

Views: 100082

Downloads: 24

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next