No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


S9300, S9300E, and S9300X V200R012C00 Configuration Guide - Ethernet Switching

This document describes the configuration of Ethernet services, including configuring MAC address table, link aggregation, VLANs, VLAN aggregation, MUX VLAN, VLAN termination, Voice VLAN, VLAN mapping, QinQ, GVRP, STP/RSTP/MSTP, VBST, SEP, RRPP, ERPS, LBDT, HVRP, and Layer 2 protocol transparent transmission.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
(Optional) Setting the VLAN Registration Timer

(Optional) Setting the VLAN Registration Timer


The HVRP root interface on each switch periodically sends user VLAN registration packets according to the VLAN registration timer. HVRP interfaces that receive registration packets from user VLANs are added to the user VLANs. The switch learns only MAC addresses in registered VLANs. This reduces the number of MAC addresses that the switch learns and improves the stability of the switch when network flapping occurs.

  • The value of the VLAN registration timer must be smaller than the value of the aging timer of registered VLANs. It is recommended that the value of the aging timer of registered VLANs be three times the value of the VLAN registration timer or larger.

  • All switches on a ring network must be configured with the same VLAN registration timer value.


  1. Run system-view

    The system view is displayed.

  2. Run hvrp timer registervlan timer-interval

    The VLAN registration timer is set.

    The default value of the VLAN registration timer is 5 seconds.

Updated: 2019-01-18

Document ID: EDOC1100038290

Views: 102934

Downloads: 24

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Previous Next