No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


S9300, S9300E, and S9300X V200R012C00 Configuration Guide - Ethernet Switching

This document describes the configuration of Ethernet services, including configuring MAC address table, link aggregation, VLANs, VLAN aggregation, MUX VLAN, VLAN termination, Voice VLAN, VLAN mapping, QinQ, GVRP, STP/RSTP/MSTP, VBST, SEP, RRPP, ERPS, LBDT, HVRP, and Layer 2 protocol transparent transmission.

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Switches Are Connected Across a Transmission Device

Switches Are Connected Across a Transmission Device

As shown in Figure 3-14, two switches are positioned far away from each other. In order for the switches to communicate, a transmission device needs to be deployed between them. In addition, to enhance link bandwidth and reliability, link aggregation is configured between the two switches. To achieve this, the following conditions must be met:

  • The switches at both ends must use link aggregation in LACP mode.
  • The transmission device between the switches must be configured to transparently transmit LACPDUs.
Figure 3-14  Switches are connected across a transmission device using link aggregation
Updated: 2019-01-18

Document ID: EDOC1100038290

Views: 125343

Downloads: 24

Average rating:
This Document Applies to these Products

Related Version

Related Documents

Previous Next