No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

S9300, S9300E, and S9300X V200R012C00 Configuration Guide - Ethernet Switching

This document describes the configuration of Ethernet services, including configuring MAC address table, link aggregation, VLANs, VLAN aggregation, MUX VLAN, VLAN termination, Voice VLAN, VLAN mapping, QinQ, GVRP, STP/RSTP/MSTP, VBST, SEP, RRPP, ERPS, LBDT, HVRP, and Layer 2 protocol transparent transmission.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
How Do I Configure a User-Side Interface on an STP Switch?

How Do I Configure a User-Side Interface on an STP Switch?

Terminal devices cannot participate in the STP calculation or respond to STP packets. You can configure a user-side interface as follows:

  • Method 1 (recommended): Run the stp edge-port enable command to configure the port as an STP edge port, and run the stp bpdu-filter enable command to enable the BPDU packet filtering function and prevent the port from sending BPDU packets. This method also prevents loops and is recommended.
  • Method 2: Run the stp disable command on the port to disable the STP protocol and make the port remain in Forwarding state.
Translation
Download
Updated: 2019-01-18

Document ID: EDOC1100038290

Views: 105449

Downloads: 24

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next