No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

S9300, S9300E, and S9300X V200R012C00 Configuration Guide - Ethernet Switching

This document describes the configuration of Ethernet services, including configuring MAC address table, link aggregation, VLANs, VLAN aggregation, MUX VLAN, VLAN termination, Voice VLAN, VLAN mapping, QinQ, GVRP, STP/RSTP/MSTP, VBST, SEP, RRPP, ERPS, LBDT, HVRP, and Layer 2 protocol transparent transmission.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Traffic Is Unevenly Load Balanced Among Eth-Trunk Member Interfaces Because the Load Balancing Mode Is Incorrect

Traffic Is Unevenly Load Balanced Among Eth-Trunk Member Interfaces Because the Load Balancing Mode Is Incorrect

Fault Description

Traffic is unevenly load balanced among Eth-Trunk member interfaces due to the incorrect load balancing mode.

Procedure

  1. Run the display eth-trunk command to check whether the load balancing mode of the Eth-Trunk meets networking requirements. For example, source or destination IP address-based load balancing is not recommended in Layer 2 networking.

  2. Run the load-balance command to set an appropriate load balancing mode.

Translation
Download
Updated: 2019-01-18

Document ID: EDOC1100038290

Views: 112942

Downloads: 24

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next