No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

S9300, S9300E, and S9300X V200R012C00 Configuration Guide - Ethernet Switching

This document describes the configuration of Ethernet services, including configuring MAC address table, link aggregation, VLANs, VLAN aggregation, MUX VLAN, VLAN termination, Voice VLAN, VLAN mapping, QinQ, GVRP, STP/RSTP/MSTP, VBST, SEP, RRPP, ERPS, LBDT, HVRP, and Layer 2 protocol transparent transmission.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Enabling VPLS-based Layer 2 Protocol Transparent Transmission on an Interface

Enabling VPLS-based Layer 2 Protocol Transparent Transmission on an Interface

Context

Perform the following operations on PEs according to the type of Layer 2 protocol packets to be transparently transmitted.

Procedure

  • Configure Layer 2 protocol transparent transmission when Ethernet interfaces are connected to the VPLS network.
    1. Run system-view

      The system view is displayed.

    2. Run interface interface-type interface-number

      The Ethernet interface view is displayed.

    3. Run undo portswitch

      The Ethernet interface is switched from Layer 2 mode to Layer 3 mode.

    4. Run l2 binding vsi vsi-name

      The Ethernet interface is bound to the VSI.

      NOTE:
      • If the remote PE is configured to receive tagged packets only, run the mpls l2vpn default vlan command to configure the default VLAN of the main interface before binding the local Ethernet interface to the VSI.

      • If the remote PE is configured to receive double-tagged packets only, run the mpls l2vpn vlan-stacking stack-vlan command to configure the stacked VLAN of the main interface before binding the local Ethernet interface to the VSI.

    5. Run l2protocol-tunnel { all | protocol-type | user-defined-protocol protocol-name } enable

      VPLS-based Layer 2 protocol transparent transmission is enabled on the interface.

  • Configure Layer 2 protocol transparent transmission when Ethernet sub-interfaces are connected to the VPLS network.
    1. Run system-view

      The system view is displayed.

    2. Run interface interface-type interface-number.subinterface-number

      The Ethernet sub-interface view is displayed.

    3. Perform one of the following operations as required.

      • Run dot1q termination vid low-pe-vid

        The single VLAN ID for dot1q encapsulation is set on a sub-interface.

      • Run qinq termination pe-vid pe-vid ce-vid ce-vid1 [ to ce-vid2 ]

        The double VLAN IDs for QinQ encapsulation are set on a sub-interface.

    4. Run l2 binding vsi vsi-name

      The Ethernet sub-interface is bound to the VSI.

    5. Run l2protocol-tunnel { all | protocol-type | user-defined-protocol protocol-name } enable

      VPLS-based Layer 2 protocol transparent transmission is enabled on the sub-interface.

Translation
Download
Updated: 2019-01-18

Document ID: EDOC1100038290

Views: 100928

Downloads: 24

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next