No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

S9300, S9300E, and S9300X V200R012C00 Configuration Guide - Ethernet Switching

This document describes the configuration of Ethernet services, including configuring MAC address table, link aggregation, VLANs, VLAN aggregation, MUX VLAN, VLAN termination, Voice VLAN, VLAN mapping, QinQ, GVRP, STP/RSTP/MSTP, VBST, SEP, RRPP, ERPS, LBDT, HVRP, and Layer 2 protocol transparent transmission.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring the VSI Associated with RRPP Snooping

Configuring the VSI Associated with RRPP Snooping

Context

If you associate an RRPP snooping-enabled sub-interface or VLANIF interface with another VSI on the device, the interface notifies the associated VSI of changes of the RRPP ring status. In this way, the VSI can immediately update the MAC address table.

You only need to configure the VSI associated with RRPP snooping on the NPE node connecting the RRPP ring to the VPLS network.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Entering the view of the interface to be enabled with RRPP snooping using the following commands as required

    • Run interface interface-type interface-number.subinterface-number

      The sub-interface view is displayed.

    • Run interface vlanif vlan-id

      The VLANIF interface view is displayed.

      The VLANIF interface in this step must map the RRPP control VLAN. For example, if the RRPP control VLAN ID is 100, the VLANIF interface here must be VLANIF 100.

  3. Configuring the VSI associated with RRPP snooping on the sub-interface or VLANIF interface using the following commands as required

    • Run rrpp snooping vsi vsi-name

      The VSI associated with RRPP snooping is configured on the sub-interface or VLANIF interface.

    • Run rrpp snooping all-vsi

      VSIs that are bound to all the other sub-interfaces connected to the same main interface are automatically associated on the sub-interface.

    NOTE:

    The rrpp snooping vsi vsi-name command associates the interface with only one VSI at a time. To associate the sub-interface or VLANIF interface with multiple VSIs, run this command multiple times.

Translation
Download
Updated: 2019-01-18

Document ID: EDOC1100038290

Views: 113221

Downloads: 24

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next