No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

S9300, S9300E, and S9300X V200R012C00 Configuration Guide - Ethernet Switching

This document describes the configuration of Ethernet services, including configuring MAC address table, link aggregation, VLANs, VLAN aggregation, MUX VLAN, VLAN termination, Voice VLAN, VLAN mapping, QinQ, GVRP, STP/RSTP/MSTP, VBST, SEP, RRPP, ERPS, LBDT, HVRP, and Layer 2 protocol transparent transmission.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Licensing Requirements and Limitations for HVRP

Licensing Requirements and Limitations for HVRP

Involved Network Elements

Other network elements also need to support HVRP.

Licensing Requirements

HVRP is a basic feature of a switch and is not under license control.

Version Requirements

Table 20-1  Products and versions supporting HVRP

Product

Product Model

Software Version

S9300

S9303, S9306, S9312

V200R005C00SPC300, V200R006C00, V200R007C00, V200R008(C00&C10), V200R009C00, V200R010C00, V200R011C10, V200R012C00, V200R013C00

S9300

S9310

V200R010C00, V200R011C10, V200R012C00, V200R013C00

S9300X

S9310X

Not supported

S9300E

S9303E, S9306E, S9312E

V200R005C00SPC300, V200R006C00, V200R007C00, V200R008(C00&C10), V200R009C00, V200R010C00, V200R011C10, V200R012C00, V200R013C00

Feature Limitations

  • After HVRP is enabled, the system dynamically sets the MAC address learning mode in a VLAN. Therefore, you do not need to set the maximum number of MAC addresses that can be learned in the VLAN.

  • HVRP and GVRP cannot be enabled simultaneously.
  • When you configure HVRP attributes, it is recommended that you delete the default VLAN (VLAN 1) from an interface.

  • After HVRP is disabled globally, HVRP is disabled on all the interfaces.

  • After HVRP is disabled on an interface, all HVRP-related configurations such as the VLAN registration timers become invalid.

Translation
Download
Updated: 2019-01-18

Document ID: EDOC1100038290

Views: 110744

Downloads: 24

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next