No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


S9300, S9300E, and S9300X V200R012C00 Configuration Guide - Ethernet Switching

This document describes the configuration of Ethernet services, including configuring MAC address table, link aggregation, VLANs, VLAN aggregation, MUX VLAN, VLAN termination, Voice VLAN, VLAN mapping, QinQ, GVRP, STP/RSTP/MSTP, VBST, SEP, RRPP, ERPS, LBDT, HVRP, and Layer 2 protocol transparent transmission.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
(Optional) Configuring LACP Preemption

(Optional) Configuring LACP Preemption


The LACP preemption function ensures that the interface with the highest LACP priority will return to functioning as an active interface after recovering from a fault. If LACP preemption is disabled, the interface cannot become active interface after it recovers.

The LACP preemption delay is the period that an inactive interface waits before changing to the active interface. The LACP preemption delay reduces the chances of instable data transmission on an Eth-Trunk due to frequent status changes of some links.


  1. Run system-view

    The system view is displayed.

  2. Run interface eth-trunk trunk-id

    The Eth-Trunk interface view is displayed.

  3. Run lacp preempt enable

    LACP preemption is enabled.

    By default, LACP preemption is disabled. To ensure normal running of an Eth-Trunk, enable or disable LACP preemption at both ends of the Eth-Trunk.

  4. Run lacp preempt delay delay-time

    The LACP preemption delay is set.

    By default, the LACP preemption delay is 30 seconds. If both devices of an Eth-Trunk use different preemption delays, the longer preemption delay becomes effective.

Updated: 2019-01-18

Document ID: EDOC1100038290

Views: 114060

Downloads: 24

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Previous Next