Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document.
Note: Even the most advanced machine translation cannot match the quality of professional translators.
Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Can I Directly Delete Inner VLAN IDs from QinQ Configuration?
- If the switch is running V100R003 or an earlier
version,
one or more inner VLAN IDs in QinQ configuration cannot be directly
deleted. You must delete the current selective QinQ configuration,
and then reconfigure the inner VLAN IDs that do not need to be deleted.
For example, if the port vlan-stacking vlan 10 to 20 stack-vlan
100 command is configured on the switch, you can perform the following
operations to delete inner VLAN 15:
- Run the undo port vlan-stacking vlan 10 to 20 stack-vlan 100 command to delete the current selective QinQ configuration.
- Run the port vlan-stacking vlan 10 to 14 stack-vlan 100 and port vlan-stacking vlan 16 to 20 stack-vlan 100 commands to reconfigure the inner VLAN IDs that do not need to be deleted.
- If the switch is running a version later than V100R003, one or more inner VLAN IDs in QinQ configuration can be directly deleted.
Previous
