No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

S9300, S9300E, and S9300X V200R012C00 Configuration Guide - Ethernet Switching

This document describes the configuration of Ethernet services, including configuring MAC address table, link aggregation, VLANs, VLAN aggregation, MUX VLAN, VLAN termination, Voice VLAN, VLAN mapping, QinQ, GVRP, STP/RSTP/MSTP, VBST, SEP, RRPP, ERPS, LBDT, HVRP, and Layer 2 protocol transparent transmission.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Summary of VBST Configuration Tasks

Summary of VBST Configuration Tasks

Table 15-2 describes the VBST configuration tasks. VBST blocks redundant links and prunes a network into a tree topology to eliminate loops and implement load balancing. You can perform the following configurations to meet requirements in special scenarios:
  • Setting VBST parameters that affect VBST convergence
  • Configuring protection functions
  • Setting parameters for interworking between a Huawei datacom device and a non-Huawei device
Table 15-2  VBST configuration task summary
Scenario Description Task

(Mandatory) Configure basic VBST functions

After you configure the operation mode of VBST and start VBST, VBST calculates the spanning tree and prunes a network into a tree network to eliminate loops. You can perform the following configurations to manually adjust the spanning tree calculation result:
  • Manually configure the root bridge and secondary root bridge.
  • Configure the switch priority. A smaller priority value indicates a higher priority of the switch and higher probability of becoming the root bridge.
  • Configure the port path cost. A smaller path cost indicates a smaller cost from the port to the root bridge and higher probability of becoming the root port.
  • Configure the port priority. A smaller priority value indicates higher probability of becoming the designated port.

Configuring VBST

(Optional) Set VBST parameters that affect VBST convergence

The network diameter, timeout interval, Hello time, Max Age, and Forward Delay affect VBST convergence. Proper settings of these parameters can speed up VBST convergence speed.

Setting VBST Parameters That Affect VBST Convergence

(Optional) Configure protection functions

Huawei datacom devices provide the following protection functions:
  • BPDU protection: prevents malicious attacks from bogus BPDUs.
  • TC protection: reduces the impact of malicious attacks from bogus TCN BPDUs.
  • Root protection: protects the role of the root bridge by retaining the role of the designated port and prevents network congestion caused by malicious attacks.
  • Loop protection: prevents loops caused by link congestion.

Configuring Protection Functions of VBST

(Optional) Set parameters for interworking between a Huawei datacom device and a non-Huawei device

To implement interworking between a Huawei datacom device and a non-Huawei device, configure the fast transition mode according to the Proposal/Agreement mechanism of the non-Huawei device.

Setting Parameters for Interworking Between a Huawei Datacom Device and a Non-Huawei Device

Translation
Download
Updated: 2019-01-18

Document ID: EDOC1100038290

Views: 111474

Downloads: 24

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next