No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

S9300, S9300E, and S9300X V200R012C00 Configuration Guide - Ethernet Switching

This document describes the configuration of Ethernet services, including configuring MAC address table, link aggregation, VLANs, VLAN aggregation, MUX VLAN, VLAN termination, Voice VLAN, VLAN mapping, QinQ, GVRP, STP/RSTP/MSTP, VBST, SEP, RRPP, ERPS, LBDT, HVRP, and Layer 2 protocol transparent transmission.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring 2:1 VLAN Mapping

Configuring 2:1 VLAN Mapping

Context

When receiving a tagged packet, an interface maps the VLAN ID in the packet to an S-VLAN ID.

NOTE:

The LE0MG24CA and LE0MG24SA cards do not support VLAN mapping for double-tagged packets.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run interface interface-type interface-number

    The interface view is displayed.

  3. Run port vlan-mapping vlan vlan-id1 inner-vlan vlan-id2 [ to vlan-id3 ] map-vlan vlan-id4 [ remark-8021p 8021p-value ]

    The outer VLAN tag is replaced.

Translation
Download
Updated: 2019-01-18

Document ID: EDOC1100038290

Views: 113773

Downloads: 24

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next