No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

S9300, S9300E, and S9300X V200R012C00 Configuration Guide - Ethernet Switching

This document describes the configuration of Ethernet services, including configuring MAC address table, link aggregation, VLANs, VLAN aggregation, MUX VLAN, VLAN termination, Voice VLAN, VLAN mapping, QinQ, GVRP, STP/RSTP/MSTP, VBST, SEP, RRPP, ERPS, LBDT, HVRP, and Layer 2 protocol transparent transmission.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Binding an E-Trunk to a BFD Session

Binding an E-Trunk to a BFD Session

Context

When the local device of an E-Trunk cannot rapidly detect whether the remote device is faulty by sending E-Trunk packets, it can use the Bidirectional Fast Detection (BFD) protocol to quickly detect faults on the remote device. You need to specify the remote IP address on the local device and create a BFD session to check the reachability of the route to the remote device. The E-Trunk then can detect faults reported by the BFD session and the faults can be processed quickly.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run e-trunk e-trunk-id

    The E-Trunk view is displayed.

  3. Run e-trunk track bfd-session session-name bfd-session-name

    The E-Trunk is bound to a BFD session.

    BFD sessions are used to quickly detect faults of the link between the two E-Trunk member devices.

    When a BFD session is bound with E-Trunk, by default, the system does not allow the bound BFD session to be deleted. To delete the bound BFD session, run the bfd session nonexistent-config-check disable command to disable the device from checking whether the bound BFD session is deleted.

Translation
Download
Updated: 2019-01-18

Document ID: EDOC1100038290

Views: 111713

Downloads: 24

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next