No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

S9300, S9300E, and S9300X V200R012C00 Configuration Guide - Ethernet Switching

This document describes the configuration of Ethernet services, including configuring MAC address table, link aggregation, VLANs, VLAN aggregation, MUX VLAN, VLAN termination, Voice VLAN, VLAN mapping, QinQ, GVRP, STP/RSTP/MSTP, VBST, SEP, RRPP, ERPS, LBDT, HVRP, and Layer 2 protocol transparent transmission.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Default Settings for STP/RSTP

Default Settings for STP/RSTP

Parameter

Default Setting

Working mode

MSTP

STP/RSTP status

Disabled globally and enabled on an interface

Switching device priority

32768

Port priority

128

Algorithm used to calculate the path cost

dot1t (IEEE 802.1t)

Forward Delay

1500 centiseconds (15 seconds)

Hello Time

200 centiseconds (2 seconds)

Max Age

2000 centiseconds (20 seconds)

Translation
Download
Updated: 2019-01-18

Document ID: EDOC1100038290

Views: 100930

Downloads: 24

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next