No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


S9300, S9300E, and S9300X V200R012C00 Configuration Guide - Ethernet Switching

This document describes the configuration of Ethernet services, including configuring MAC address table, link aggregation, VLANs, VLAN aggregation, MUX VLAN, VLAN termination, Voice VLAN, VLAN mapping, QinQ, GVRP, STP/RSTP/MSTP, VBST, SEP, RRPP, ERPS, LBDT, HVRP, and Layer 2 protocol transparent transmission.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring Local and Remote IP Addresses of an E-Trunk

Configuring Local and Remote IP Addresses of an E-Trunk


E-Trunk packets are sent with the source IP address and protocol port number configured on the local device. When you change the local or remote IP address on a device, you must change the corresponding address on the remote device. Otherwise, E-Trunk packets are dropped.


  1. Run system-view

    The system view is displayed.

  2. Run e-trunk e-trunk-id

    The E-Trunk view is displayed.

  3. Run peer-address peer-ip-address source-address source-ip-address

    The local and remote IP addresses of the E-Trunk are configured.

    The remote IP address of the local device must be the same as the local IP address of the remote device. For example, when an E-Trunk is created between device A and device B and the local and remote IP addresses on device A are and respectively, the local and remote IP addresses on device B must be and respectively.

Updated: 2019-01-18

Document ID: EDOC1100038290

Views: 112973

Downloads: 24

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Previous Next