No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

S9300, S9300E, and S9300X V200R012C00 Configuration Guide - Ethernet Switching

This document describes the configuration of Ethernet services, including configuring MAC address table, link aggregation, VLANs, VLAN aggregation, MUX VLAN, VLAN termination, Voice VLAN, VLAN mapping, QinQ, GVRP, STP/RSTP/MSTP, VBST, SEP, RRPP, ERPS, LBDT, HVRP, and Layer 2 protocol transparent transmission.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring a Traffic Policy to Implement Intra-VLAN Layer 2 Isolation

Configuring a Traffic Policy to Implement Intra-VLAN Layer 2 Isolation

After VLANs are assigned, users in the same VLAN can communicate with each other. You must configure a traffic policy if users in a VLAN need to be isolated unidirectionally or bidirectionally.

Context

A QoS policy is configured by binding traffic classifiers to traffic behaviors. The switch implements intra-VLAN isolation by classifying packets according to packet information, and associating a traffic classifier with a traffic behavior to reject the packets matching the traffic classifier.

The switch provides intra-VLAN Layer 2 isolation based on MQC and the simplified ACL-based traffic policy.

Pre-configuration Tasks

Before configuring a traffic policy to implement intra-VLAN Layer 2 isolation, perform the task of assigning VLANs.

Procedure

  • Configure MQC to implement intra-VLAN Layer 2 isolation.

    Perform the following MQC configurations to implement intra-VLAN Layer 2 isolation:
    • Specify permit or deny in the traffic behavior.
    • Apply the traffic policy to a VLAN or an interface that allows the VLAN.

    For details about how to configure MQC, see Configuring Packet Filtering in "Packet Filtering Configuration" in the S9300, S9300E, and S9300X V200R012C00 Configuration Guide - QoS.

  • Configure an ACL-based simplified traffic policy to implement intra-VLAN Layer 2 isolation.

    For details about how to configure an ACL-based simplified traffic policy, see Configuring ACL-based Packet Filtering in "ACL-based Simplified Traffic Policy Configuration" in the S9300, S9300E, and S9300X V200R012C00 Configuration Guide - QoS.

Translation
Download
Updated: 2019-01-18

Document ID: EDOC1100038290

Views: 100691

Downloads: 24

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next