No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

S9300, S9300E, and S9300X V200R012C00 Configuration Guide - Ethernet Switching

This document describes the configuration of Ethernet services, including configuring MAC address table, link aggregation, VLANs, VLAN aggregation, MUX VLAN, VLAN termination, Voice VLAN, VLAN mapping, QinQ, GVRP, STP/RSTP/MSTP, VBST, SEP, RRPP, ERPS, LBDT, HVRP, and Layer 2 protocol transparent transmission.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
How Do I Determine the Number of Member Interfaces in an Eth-Trunk?

How Do I Determine the Number of Member Interfaces in an Eth-Trunk?

To ensure normal forwarding of burst traffic on an Eth-Trunk, the total bandwidth of the Eth-Trunk must be higher than the bandwidth of an interface that forwards normal traffic. To ensure that member interfaces of an Eth-Trunk evenly load balance traffic, you can use two, four, or eight member interfaces.

Translation
Download
Updated: 2019-01-18

Document ID: EDOC1100038290

Views: 103509

Downloads: 24

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next