No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


S9300, S9300E, and S9300X V200R012C00 Configuration Guide - Ethernet Switching

This document describes the configuration of Ethernet services, including configuring MAC address table, link aggregation, VLANs, VLAN aggregation, MUX VLAN, VLAN termination, Voice VLAN, VLAN mapping, QinQ, GVRP, STP/RSTP/MSTP, VBST, SEP, RRPP, ERPS, LBDT, HVRP, and Layer 2 protocol transparent transmission.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Application Scenarios for MSTP

Application Scenarios for MSTP

Application of MSTP

Figure 14-15  Network of a typical MSTP application

MSTP allows packets in different VLANs to be forwarded by using different spanning tree instances. An example of a network using MSTP is shown in Figure 14-15. The network is configured in the following ways:

  • All devices on the network belong to the same MST region.

  • VLAN 10 packets are forwarded within MSTI 1.

  • VLAN 30 packets are forwarded within MSTI 3.

  • VLAN 40 packets are forwarded within MSTI 4.

  • VLAN 20 packets are forwarded within MSTI 0.

In Figure 14-15, S1 and S2 are devices at the aggregation layer, and S3 and S4 are devices at the access layer. Traffic from VLAN 10 and VLAN 30 is terminated by aggregation devices, and traffic from VLAN 40 is terminated by the access device. Therefore, S1 and S2 can be configured as the roots of MSTI 1 and MSTI 3, and S3 can be configured as the root of MSTI 4.

Application of MSTP Multi-process

In Figure 14-16, the UPEs are connected to each other through Layer 2 links and enabled with MSTP. The rings connected to the UPEs must be independent of each other. The devices on the rings connected to the UPEs support only RSTP, not MSTP.

After MSTP multi-process is enabled, each MSTP process corresponds to a ring connected to the UPE. STP on each ring calculates a tree independently.

Figure 14-16  Application of both MSTP and STP/RSTP

Updated: 2019-01-18

Document ID: EDOC1100038290

Views: 113425

Downloads: 24

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Previous Next