No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

S9300, S9300E, and S9300X V200R012C00 Configuration Guide - Ethernet Switching

This document describes the configuration of Ethernet services, including configuring MAC address table, link aggregation, VLANs, VLAN aggregation, MUX VLAN, VLAN termination, Voice VLAN, VLAN mapping, QinQ, GVRP, STP/RSTP/MSTP, VBST, SEP, RRPP, ERPS, LBDT, HVRP, and Layer 2 protocol transparent transmission.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Maintaining Link Aggregation

Maintaining Link Aggregation

Maintaining link aggregation includes monitoring the link aggregation running status and clearing LACPDU statistics.

Maintenance Item

Operation

Displaying inbound and outbound interfaces of specified flows

  1. Run the system-view command to enter the system view.
  2. Run the collect forward-path { { sip source-ip-address dip destination-ip-address [ sport source-port dport destination-port [ protocol { protocol-number | gre | icmp | igmp | ip | ipinip | ospf | tcp | udp } ] ] } | { smac source-mac-address | dmac dest-mac-address | vlan vlan-id | l2-protocol { protocol-value | arp | ip | ipv6 | mpls | rarp } } * } { ingress | egress | both } [ interval interval-time ] command to configure the device to collect inbound and outbound interfaces and traffic information about packets with 5-tuple information.
  3. Run the display forward-path command to check information about the collect forward-path command and the report ID. That is, the value of report-id in the display forward-path report command.
  4. Run the display forward-path report report-id command to check the inbound and outbound interfaces of packets with 5-tuple information and statistics.
    NOTE:

    You can run the display forward-path command to view the value of report-id.

Displaying the Eth-Trunk configuration

Run the display eth-trunk [ trunk-id [ interface interface-type interface-number | verbose ] ] command to check the Eth-Trunk configuration.

Displaying the Eth-Trunk status

Run the display interface eth-trunk [ trunk-id ] command.

Displaying information about Eth-Trunk member interfaces

Run the display trunkmembership eth-trunk trunk-id command.

Displaying statistics on received and sent LACPDUs in LACP mode

Run the display lacp statistics eth-trunk [ trunk-id [ interface interface-type interface-number ] ] command.

Clearing LACPDU statistics

NOTICE:

The cleared LACPDU statistics cannot be restored.

Run the reset lacp statistics eth-trunk [ trunk-id [ interface interface-type interface-number ] ] command in the user view.

Translation
Download
Updated: 2019-01-18

Document ID: EDOC1100038290

Views: 101376

Downloads: 24

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next