No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

S9300, S9300E, and S9300X V200R012C00 Configuration Guide - Ethernet Switching

This document describes the configuration of Ethernet services, including configuring MAC address table, link aggregation, VLANs, VLAN aggregation, MUX VLAN, VLAN termination, Voice VLAN, VLAN mapping, QinQ, GVRP, STP/RSTP/MSTP, VBST, SEP, RRPP, ERPS, LBDT, HVRP, and Layer 2 protocol transparent transmission.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Reporting Topology Changes in a Lower-Layer Network - Enabling the Devices in a SEP Segment to Process SmartLink Flush Packets

Reporting Topology Changes in a Lower-Layer Network - Enabling the Devices in a SEP Segment to Process SmartLink Flush Packets

Context

When a host is connected to a SEP network using a SmartLink group, the host sends SmartLink Flush packets to inform the remote device in the SEP segment if devices in the SmartLink group experience an active/standby switchover. Therefore, devices in a SEP segment must be able to process SmartLink Flush packets.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run sep segment segment-id

    A SEP segment is created and the view of the SEP segment is displayed.

  3. Run deal smart-link-flush

    The device in a SEP segment is configured to process SmartLink Flush packets.

    By default, no device in a SEP segment is configured to process SmartLink Flush packets.

  4. Run quit

    Return to the system view.

  5. Run interface interface-type interface-number

    The interface view is displayed.

  6. Run smart-link flush receive control-vlan vlan-id [ password { simple | sha } password ]

    The interface is configured to receive Flush packets.

    By default, an interface is prohibited from receiving Flush packets.

    The password parameter is optional. If no password is specified, no password is used for authentication.

    The control VLAN ID and password contained in Flush packets on both devices must be the same.

Translation
Download
Updated: 2019-01-18

Document ID: EDOC1100038290

Views: 113464

Downloads: 24

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next