No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

S9300, S9300E, and S9300X V200R012C00 Configuration Guide - Ethernet Switching

This document describes the configuration of Ethernet services, including configuring MAC address table, link aggregation, VLANs, VLAN aggregation, MUX VLAN, VLAN termination, Voice VLAN, VLAN mapping, QinQ, GVRP, STP/RSTP/MSTP, VBST, SEP, RRPP, ERPS, LBDT, HVRP, and Layer 2 protocol transparent transmission.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Using E-Trunk Between Multiple PEs Connected to a CE

Using E-Trunk Between Multiple PEs Connected to a CE

As shown in Figure 3-18, the Enhanced Trunk (E-Trunk) protects the links between CE1 and two PEs (PE1 and PE2) on the network. CE1 is connected to PE1 and PE2 using two Eth-Trunks in LACP mode. The two Eth-Trunks form an E-Trunk to implement backup and enhance the network reliability.

Figure 3-18  E-Trunk networking

Translation
Download
Updated: 2019-01-18

Document ID: EDOC1100038290

Views: 100701

Downloads: 24

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next