No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

S9300, S9300E, and S9300X V200R012C00 Configuration Guide - Ethernet Switching

This document describes the configuration of Ethernet services, including configuring MAC address table, link aggregation, VLANs, VLAN aggregation, MUX VLAN, VLAN termination, Voice VLAN, VLAN mapping, QinQ, GVRP, STP/RSTP/MSTP, VBST, SEP, RRPP, ERPS, LBDT, HVRP, and Layer 2 protocol transparent transmission.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring VBST

Configuring VBST

After you configure the operation mode of VBST and start VBST, VBST calculates the spanning tree and prunes a network into a tree network to eliminate loops. Network planners can also set parameters such as the switch priority, port path cost, and port priority to adjust the spanning tree calculation result.

Pre-configuration Tasks

Before configuring basic VBST functions, connect ports and set the physical parameters of each interface to make the physical layer in Up state. For details, see Basic Configuration for Interfaces and Ethernet Interface Configuration in the S9300, S9300E, and S9300X V200R012C00 Configuration Guide - Interface Management.

Translation
Download
Updated: 2019-01-18

Document ID: EDOC1100038290

Views: 100058

Downloads: 24

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next