No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


S9300, S9300E, and S9300X V200R012C00 Configuration Guide - Ethernet Switching

This document describes the configuration of Ethernet services, including configuring MAC address table, link aggregation, VLANs, VLAN aggregation, MUX VLAN, VLAN termination, Voice VLAN, VLAN mapping, QinQ, GVRP, STP/RSTP/MSTP, VBST, SEP, RRPP, ERPS, LBDT, HVRP, and Layer 2 protocol transparent transmission.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring Interfaces on an RRPP Ring

Configuring Interfaces on an RRPP Ring


Data in different VLANs is transmitted on the RRPP ring, including data VLANs and control VLANs. You need to configure an interface to allow data from these VLANs to pass through, ensuring data transmission on the ring.

RRPP cannot be configured on an interface configured with Smart Link, Loopback Detection (LDT), MUX VLAN, or MSTP. Before configuring RRPP, ensure that the interface is not configured with protocols that conflict with RRPP.


  1. Run system-view

    The system view is displayed.

  2. Run interface interface-type interface-number

    The interface view is displayed.

  3. Run port hybrid tagged vlan { { vlan-id1 [ to vlan-id2 ] }&<1-10> | all }

    The VLAN allowed by an RRPP-enabled interface is specified.

    An RRPP-enabled interface needs to allow packets of control VLANs and data VLANs to pass through, so the interface must be configured as a trunk or hybrid interface. By default, an interface is a hybrid interface. You can also configure the interface as a trunk interface.

    After the control-vlan command is use in the RRPP domain view to configure a control VLAN and the ring node-mode command is configured, the interfaces on the RRPP ring allow packets of the control VLAN to pass through. Therefore, you need to specify only the IDs of data VLANs in this step.


    If RRPP snooping is enabled on the VLANIF interface of a VLAN, RRPP-enabled interfaces cannot be added to the VLAN.

  4. Run stp disable

    STP is disabled on the RRPP interface.

    RRPP and STP cannot be configured on an interface simultaneously. By default, STP is enabled on all the interfaces on the device. Therefore, before creating an RRPP ring, disable STP on the interfaces that need to be added to the RRPP ring.

Updated: 2019-01-18

Document ID: EDOC1100038290

Views: 113558

Downloads: 24

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Previous Next