No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - Ethernet Switching

S1720, S2700, S5700, and S6720 V200R012(C00 and C20)

This document describes the configuration of Ethernet services, including configuring MAC address table, link aggregation, VLANs, VLAN aggregation, MUX VLAN, VLAN termination, Voice VLAN, VLAN mapping, QinQ, GVRP, VCMP, STP/RSTP/MSTP, VBST, SEP, RRPP, ERPS, LBDT, and Layer 2 protocol transparent transmission.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Summary of ERPS Configuration Tasks

Summary of ERPS Configuration Tasks

After a single ERPS ring or intersecting ERPS ring is configured, a specified port can be blocked to remove loops. Table 18-5 describes the ERPS configuration tasks.

Table 18-5  ERPS configuration tasks

Scenario

Description

Task

Configure ERPS single-ring networking

You can configure ERPS single-ring networking when there is only one ring in the network topology.

Configuring ERPSv1

Configure ERPS intersecting-ring networking

You can configure ERPS intersecting-ring networking when there are two or more rings in the network topology and many common nodes between two rings.

Configuring ERPSv2

Configure association between ERPS and CFM

ERPS cannot automatically detect link faults. When there are transmission devices in an ERPS ring, ERPS cannot detect whether faults on transmission devices cause slow convergence and traffic interruption. Association between ERPS and CFM solves this problem.

(Optional) Configuring Association Between ERPS and Ethernet CFM

Translation
Download
Updated: 2018-12-24

Document ID: EDOC1100038339

Views: 167304

Downloads: 699

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next