No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - Ethernet Switching

S1720, S2700, S5700, and S6720 V200R012(C00 and C20)

This document describes the configuration of Ethernet services, including configuring MAC address table, link aggregation, VLANs, VLAN aggregation, MUX VLAN, VLAN termination, Voice VLAN, VLAN mapping, QinQ, GVRP, VCMP, STP/RSTP/MSTP, VBST, SEP, RRPP, ERPS, LBDT, and Layer 2 protocol transparent transmission.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Overview of GVRP

Overview of GVRP

Definition

The Generic Attribute Registration Protocol (GARP) provides a mechanism for propagating attributes so that a protocol entity can register and deregister attributes. By filling different attributes into GARP packets, GARP supports various upper-layer applications.

The GARP VLAN Registration Protocol (GVRP) is used to register and deregister VLAN attributes.

GARP identifies applications through destination MAC addresses. IEEE Std 802.1Q assigns 01-80-C2-00-00-21 to the VLAN application (GVRP).

Purpose

To deploy a VLAN on all devices on a network, a network administrator must manually create it on each device. In Figure 11-1, three routers are connected through trunk links. VLAN 2 is configured on SwitchA, and VLAN 1 is configured on SwitchB and SwitchC. To forward packets of VLAN 2 from SwitchA to SwitchC, the network administrator must manually create VLAN 2 on SwitchB and SwitchC.

Figure 11-1  GVRP application

When a network is complex and the network administrator is unfamiliar with the network topology, or when many VLANs are configured on the network, the manual configuration workload is enormous. In addition, configuration errors may occur due to human error. GVRP can be configured on the network to implement automatic registration of VLANs, reducing configuration workload and the likelihood of configuration errors.

Benefits

GVRP is based on GARP. It dynamically maintains VLAN attributes on devices. Using GVRP, VLAN attributes of one device can be propagated throughout the entire switching network. GVRP enables network devices to dynamically deliver, register, and propagate VLAN attributes, reducing the workload of the network administrator and helping to ensure correct configuration.

Translation
Download
Updated: 2018-12-24

Document ID: EDOC1100038339

Views: 168119

Downloads: 701

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next