No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - Ethernet Switching

S1720, S2700, S5700, and S6720 V200R012(C00 and C20)

This document describes the configuration of Ethernet services, including configuring MAC address table, link aggregation, VLANs, VLAN aggregation, MUX VLAN, VLAN termination, Voice VLAN, VLAN mapping, QinQ, GVRP, VCMP, STP/RSTP/MSTP, VBST, SEP, RRPP, ERPS, LBDT, and Layer 2 protocol transparent transmission.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
SEP Multi-Instance

SEP Multi-Instance

In Figure 16-15, SEP multi-instance allows two SEP segments to be configured on a physical ring. Each SEP segment independently detects the completeness of a physical ring and blocks or unblocks interfaces without affecting the other.

A physical ring may contain one or two SEP segments. Each SEP segment needs to be configured with a protected instance, each protected instance indicating a VLAN range. The topology calculated by a SEP segment is only valid for that SEP segment.

After different protected instances are configured for SEP segments and the mapping between protected instances and VLANs is set, a blocked interface is only valid for the VLANs protected by the SEP segment where the blocked interface resides. Data traffic for different VLANs can be transmitted along different paths. This implements traffic load balancing and link backup.

Figure 16-15  Networking diagram for SEP multi-instance

Translation
Download
Updated: 2018-12-24

Document ID: EDOC1100038339

Views: 166105

Downloads: 695

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next