No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - Ethernet Switching

S1720, S2700, S5700, and S6720 V200R012(C00 and C20)

This document describes the configuration of Ethernet services, including configuring MAC address table, link aggregation, VLANs, VLAN aggregation, MUX VLAN, VLAN termination, Voice VLAN, VLAN mapping, QinQ, GVRP, VCMP, STP/RSTP/MSTP, VBST, SEP, RRPP, ERPS, LBDT, and Layer 2 protocol transparent transmission.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Summary of QinQ Configuration Tasks

Summary of QinQ Configuration Tasks

Table 9-6 describes the QinQ configuration tasks.

Table 9-6  Summary of QinQ configuration tasks
Scenario Description Task

Configure basic QinQ

After basic QinQ is configured, the switch adds a public tag to incoming packets so that user packets can be forwarded on the public network.

Configuring Basic QinQ

Configure selective QinQ

Selective QinQ based on VLAN IDs enables the switch to add different outer VLAN tags to received data frames according to VLAN IDs in the frames.

Configuring Selective QinQ

Set the TPID value in an outer VLAN tag

This configuration allows a Huawei device to communicate with a non-Huawei device.

Configuring the TPID Value in an Outer VLAN Tag

Configure QinQ stacking on a VLANIF interface

To log in to a remote device and manage the device, you can configure QinQ stacking on the VLANIF interface corresponding to the management VLAN of the remote device.

Configuring QinQ Stacking on a VLANIF Interface

Configure the device to add double VLAN tags to untagged packets

The device can be configured to add double VLAN tags to untagged packets.

Configuring the Switch to Add Double VLAN Tags to Untagged Packets

Configure QinQ mapping

QinQ mapping maps C-VLAN tags to S-VLAN tags to shield different C-VLAN tags.

Configuring QinQ Mapping

Translation
Download
Updated: 2018-12-24

Document ID: EDOC1100038339

Views: 169548

Downloads: 703

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next