No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - Ethernet Switching

S1720, S2700, S5700, and S6720 V200R012(C00 and C20)

This document describes the configuration of Ethernet services, including configuring MAC address table, link aggregation, VLANs, VLAN aggregation, MUX VLAN, VLAN termination, Voice VLAN, VLAN mapping, QinQ, GVRP, VCMP, STP/RSTP/MSTP, VBST, SEP, RRPP, ERPS, LBDT, and Layer 2 protocol transparent transmission.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Switches Connect to Transmission Devices

Switches Connect to Transmission Devices

As shown in Figure 3-15, one core site and multiple access sites are deployed. The sites are far away from each other, so transmission devices need to be deployed between devices to ensure communication. At each site, link aggregation is deployed between the switch and the transmission device to improve the link reliability.

  • The link aggregation mode on the transmission device must be the same as that of the switch. Configure the transmission device according to its operation guide.
Figure 3-15  Switches are connected to transmission devices using link aggregation
Translation
Download
Updated: 2018-12-24

Document ID: EDOC1100038339

Views: 156306

Downloads: 680

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next