No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - Ethernet Switching

S1720, S2700, S5700, and S6720 V200R012(C00 and C20)

This document describes the configuration of Ethernet services, including configuring MAC address table, link aggregation, VLANs, VLAN aggregation, MUX VLAN, VLAN termination, Voice VLAN, VLAN mapping, QinQ, GVRP, VCMP, STP/RSTP/MSTP, VBST, SEP, RRPP, ERPS, LBDT, and Layer 2 protocol transparent transmission.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring a Protected VLAN

Configuring a Protected VLAN

Context

The device controls only data in the protected VLANs based on RRPP. Data out of the protected VLANs may cause storms on the ring network.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run rrpp domain domain-id

    The RRPP domain view is displayed.

  3. Run protected-vlan reference-instance { { instance-id1 [ to instance-id2 ] } &<1-10> | all }

    The list of protected VLANs in the RRPP domain is configured.

    All the VLANs whose packets need to pass through an RRPP interface, including the control VLANs and data VLANs, must be configured as protected VLANs.

    NOTE:

    When you configure the list of protected VLANs, note the following points:

    • Protected VLANs must be configured before you configure an RRPP ring.

    • You can delete or change existing protected VLANs before configuring an RRPP ring. The protected VLANs cannot be changed after the RRPP ring is configured.

    • In the same physical topology, the control VLAN in a domain cannot be configured as a protected VLAN in another domain.

    • The control VLAN must be included in the protected VLANs; otherwise, the RRPP ring cannot be configured.

    • The control VLAN can be mapped to other instances before the RRPP ring is created. After the RRPP ring is created, the mapping cannot be changed unless you delete the RRPP ring.

    • When the mapping between an instance and VLANs changes, the protected VLANs in the RRPP domain also change.

    • All the VLANs allowed by an RRPP interface must be configured as protected VLANs.

Translation
Download
Updated: 2018-12-24

Document ID: EDOC1100038339

Views: 166129

Downloads: 695

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next