No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - Ethernet Switching

S1720, S2700, S5700, and S6720 V200R012(C00 and C20)

This document describes the configuration of Ethernet services, including configuring MAC address table, link aggregation, VLANs, VLAN aggregation, MUX VLAN, VLAN termination, Voice VLAN, VLAN mapping, QinQ, GVRP, VCMP, STP/RSTP/MSTP, VBST, SEP, RRPP, ERPS, LBDT, and Layer 2 protocol transparent transmission.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
(Optional) Setting the Lower Threshold for the Number of Active Interfaces

(Optional) Setting the Lower Threshold for the Number of Active Interfaces

Context

The lower threshold for the number of active interfaces affects the status and bandwidth of an Eth-Trunk. To ensure that the Eth-Trunk functions properly and is less affected by member link status changes, set the lower threshold for the number of active interfaces.

When the number of active interfaces falls below the lower threshold, the Eth-Trunk goes Down. This ensures that the Eth-Trunk has a minimum available bandwidth.

The upper threshold for the number of active interfaces is inapplicable to the manual load balancing mode.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run interface eth-trunk trunk-id

    The Eth-Trunk interface view is displayed.

  3. Run least active-linknumber link-number

    The lower threshold for the number of active interfaces is set.

    By default, the lower threshold for the number of active interfaces is 1.

    The lower threshold for the number of active interfaces on the local switch can be different from that on the remote switch.

Translation
Download
Updated: 2018-12-24

Document ID: EDOC1100038339

Views: 161587

Downloads: 688

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next