No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - Ethernet Switching

S1720, S2700, S5700, and S6720 V200R012(C00 and C20)

This document describes the configuration of Ethernet services, including configuring MAC address table, link aggregation, VLANs, VLAN aggregation, MUX VLAN, VLAN termination, Voice VLAN, VLAN mapping, QinQ, GVRP, VCMP, STP/RSTP/MSTP, VBST, SEP, RRPP, ERPS, LBDT, and Layer 2 protocol transparent transmission.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Adding Member Interfaces to an Eth-Trunk

Adding Member Interfaces to an Eth-Trunk

Context

Before adding member interfaces to an Eth-Trunk, read the configuration notes. See Licensing Requirements and Limitations for Link Aggregation.

You can add member interfaces to an Eth-Trunk in the Eth-Trunk interface view or member interface view.

Procedure

  • Add member interfaces to an Eth-Trunk in the Eth-Trunk interface view.
    1. Run system-view

      The system view is displayed.

    2. Run interface eth-trunk trunk-id

      The Eth-Trunk interface view is displayed.

    3. (Optional) Run mixed-rate link enable

      Interfaces with different rates are allowed to join the same Eth-Trunk.

      By default, interfaces with different rates are not allowed to join the same Eth-Trunk.

    4. Run trunkport interface-type { interface-number1 [ to interface-number2 ] } &<1-8> [ mode { active | passive } ]

      A member interface is added to the Eth-Trunk.

      NOTE:

      When you add member interfaces to an Eth-Trunk in a batch, if one interface fails to be added to the Eth-Trunk, subsequent interfaces in the batch cannot be added to the Eth-Trunk.

  • Add member interfaces to an Eth-Trunk in the member interface view.
    1. Run system-view

      The system view is displayed.

    2. (Optional) Add interfaces with different rates to the same Eth-Trunk.

      1. Run interface eth-trunk trunk-id

        The Eth-Trunk interface view is displayed.

      2. Run mixed-rate link enable

        Interfaces with different rates are allowed to join the same Eth-Trunk.

        By default, interfaces with different rates are not allowed to join the same Eth-Trunk.

      3. Run quit

        Return to the system view.

    3. Run interface interface-type interface-number

      The member interface view is displayed.

    4. Run eth-trunk trunk-id [ mode { active | passive } ]

      The member interface is added to an Eth-Trunk.

    When adding an interface to an Eth-Trunk, pay attention to the following points:

    • An Ethernet interface can be added to only one Eth-Trunk. To add an Ethernet interface to another Eth-Trunk, delete it from the original one first.
    • After interfaces are added to an Eth-Trunk, the Eth-Trunk learns MAC addresses and ARP entries but member interfaces do not.
    • Before deleting an Eth-Trunk, delete member interfaces from the Eth-Trunk.

Translation
Download
Updated: 2018-12-24

Document ID: EDOC1100038339

Views: 168563

Downloads: 703

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next