No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Configuration Guide - Ethernet Switching

S1720, S2700, S5700, and S6720 V200R012(C00 and C20)

This document describes the configuration of Ethernet services, including configuring MAC address table, link aggregation, VLANs, VLAN aggregation, MUX VLAN, VLAN termination, Voice VLAN, VLAN mapping, QinQ, GVRP, VCMP, STP/RSTP/MSTP, VBST, SEP, RRPP, ERPS, LBDT, and Layer 2 protocol transparent transmission.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
STP/RSTP Background

STP/RSTP Background

STP prevents loops on a local area network (LAN). Devices running STP exchange information with one another to discover loops on the network, and block certain ports to eliminate loops. With the growth in scale of LANs, STP has become an important protocol for a LAN.

Figure 13-1  Typical LAN networking

On the network shown in Figure 13-1, the following situations may occur:
  • Broadcast storms cause a breakdown of the network.

    If a loop exists on the network, broadcast storms may occur, leading to a breakdown of the network. In Figure 13-1, STP is not enabled on the switches. If Host A sends a broadcast request, both S1 and S2 receive the request on port 1 and forward the request through their port 2. Then, S1 and S2 receive the request forwarded by each other on port 2 and forward the request through port 1. As this process repeats, resources on the entire network are exhausted, and the network finally breaks down.

  • MAC address table flapping causes unstable MAC address entries.

    Assume that no broadcast storm has occurred on the network shown in Figure 13-1. HostA sends a unicast packet to HostB. If HostB is temporarily removed from the network at this time, the MAC address entry for HostB will be deleted on S1 and S2. The unicast packet sent by HostA to HostB is received by port 1 on S1. S1 has no matching MAC address entry, so the unicast packet is forwarded to port 2. Then port 2 on S2 receives the unicast packet from port 2 on S1 and sends it out through port 1. In addition, port 1 on S2 also receives the unicast packet sent by HostA to HostB, and sends it out through port 2. As such transmissions repeat, port 1 and port 2 on S1 and S2 continuously receive unicast packets from HostA. S1 and S2 modify the MAC address entries continuously, causing the MAC address table to flap. As a result, MAC address entries are damaged.

Updated: 2018-12-24

Document ID: EDOC1100038339

Views: 158698

Downloads: 685

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Previous Next