No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - Ethernet Switching

S1720, S2700, S5700, and S6720 V200R012(C00 and C20)

This document describes the configuration of Ethernet services, including configuring MAC address table, link aggregation, VLANs, VLAN aggregation, MUX VLAN, VLAN termination, Voice VLAN, VLAN mapping, QinQ, GVRP, VCMP, STP/RSTP/MSTP, VBST, SEP, RRPP, ERPS, LBDT, and Layer 2 protocol transparent transmission.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring SEP Multi-Instance

Configuring SEP Multi-Instance

Applicable Environment

In typical SEP networking, a physical ring can be configured with only one SEP segment in which only one interface can be blocked. If an interface in a complete SEP segment is blocked, all service data is transmitted only along the path where the primary edge interface is located. The path where the secondary edge interface is located remains idle, wasting bandwidth.

Figure 16-17  Networking diagram for SEP multi-instance

SEP multi-instance is used to improve bandwidth efficiency and implement traffic load balancing and link backup. In Figure 16-17, multiple instances are deployed in the SEP segment, and protected instances are mapped to different VLANs. Data traffic for different VLANs can be transmitted along different paths.

NOTE:

Currently, SEP multi-instance allows two SEP segments to be configured on a physical ring. Different blocked interfaces and priorities need to be configured for the two SEP segments.

Pre-configuration Tasks

Before configuring SEP multi-instance, complete the following tasks:

  • Configure basic SEP functions.
  • Specify an interface to block.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run stp region-configuration

    The MST region view is displayed.

  3. Run instance instance-id vlan { vlan-id [ to vlan-id ] } &<1-10>

    Mappings between protected instances and VLANs are configured.

    The value of instance-id specified in this command must be the same as that of instance-id specified in the protected-instance command.

    Before you switch a VLAN from one SEP segment to another segment, shut down the blocked port. If you do not shut down the blocked port, a routing loop may occur after the VLAN switchover.

    NOTE:

    To configure the mapping between the protected instance and MUX VLAN, you are advised to configure the principal VLAN, and subordinate group VLANs and subordinate separate VLANs of the MUX VLAN in the same protected instance. Otherwise, loops may occur.

  4. Run active region-configuration

    Mappings between protected instances and VLANs are activated.

    After mappings between protected instances and VLANs take effect, topology changes of a SEP segment affect only corresponding VLANs. This ensures reliable service data transmission.

Verifying the Configuration

Run the display stp region-configuration command to check the effective configuration of the MST region.

Translation
Download
Updated: 2018-12-24

Document ID: EDOC1100038339

Views: 158488

Downloads: 685

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next