No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Configuration Guide - Ethernet Switching

S1720, S2700, S5700, and S6720 V200R012(C00 and C20)

This document describes the configuration of Ethernet services, including configuring MAC address table, link aggregation, VLANs, VLAN aggregation, MUX VLAN, VLAN termination, Voice VLAN, VLAN mapping, QinQ, GVRP, VCMP, STP/RSTP/MSTP, VBST, SEP, RRPP, ERPS, LBDT, and Layer 2 protocol transparent transmission.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Application Scenarios for VLAN Mapping

Application Scenarios for VLAN Mapping

  • 1:1 VLAN mapping

    When receiving a single-tagged packet, the interface maps the VLAN tag to a specified single VLAN tag.

    1:1 VLAN mapping applies to the network shown in Figure 10-2.

    Figure 10-2  1:1 VLAN mapping

    In the networking diagram shown in Figure 10-2, services (HSI, IPTV, and VoIP) of each user are transmitted on different VLANs. Same services are transmitted on the same C-VLAN. To differentiate users, deploy Corridor Switch to allow the same services used by different users to be transmitted on different VLANs, which implements 1:1 VLAN mapping. 1:1 VLAN mapping requires a large number of VLANs to isolate services of different users; however, the VLAN quantity provided by the network access device at the aggregation layer is limited. To resolve this problem, configure the VLAN aggregation function to allow the same services to be transmitted on the same VLAN (N:1 VLAN mapping).

  • 2:1 VLAN mapping

    When the interface receives a double-tagged packet, the interface maps the outer VLAN tag in the packet to an S-VLAN tag and transparently transmits the inner VLAN tag.

    2:1 VLAN mapping applies to the network shown in Figure 10-3.

    Figure 10-3  2:1 VLAN mapping

    In the networking diagram shown in Figure 10-3, Residential Gateway, Corridor Switch, and Community Switch are connected to the aggregation layer on the network. To differentiate users and services to facilitate network management and charging, configure the QinQ function for Corridor Switch. To save VLAN resources, configure VLAN mapping on Community Switch to transmit the same services on the same VLAN.

  • 2:2 VLAN mapping

    2:2 VLAN mapping applies to the network shown in Figure 10-4.

    Figure 10-4  2:2 VLAN mapping

    In the networking diagram shown in Figure 10-4, QinQ is used to send double-tagged packets, which prevents the conflict between C-VLAN IDs and S-VLAN IDs and differentiates services and users. However, the interface will discard the packets because C-VLAN IDs are different from S-VLAN IDs. To ensure communication continuity, configure 2:2 VLAN mapping on the PE and replace double C-VLAN tags with double S-VLAN tags.

Updated: 2018-12-24

Document ID: EDOC1100038339

Views: 169496

Downloads: 703

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Previous Next