No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - Ethernet Switching

S1720, S2700, S5700, and S6720 V200R012(C00 and C20)

This document describes the configuration of Ethernet services, including configuring MAC address table, link aggregation, VLANs, VLAN aggregation, MUX VLAN, VLAN termination, Voice VLAN, VLAN mapping, QinQ, GVRP, VCMP, STP/RSTP/MSTP, VBST, SEP, RRPP, ERPS, LBDT, and Layer 2 protocol transparent transmission.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
VLAN Stacking on a VLANIF Interface

VLAN Stacking on a VLANIF Interface

As shown in Figure 9-5, DeviceA is connected to DeviceB through a third-party network. DeviceB belongs to the management VLAN. The management VLAN ID is the same as the VLAN ID of the downstream user connected to DeviceA but different from the service VLAN (S-VLAN) ID.

Figure 9-5  Networking diagram of VLAN stacking on a VLANIF interface

To log in to DeviceB and manage VLANs from DeviceA, you can configure VLAN stacking on the VLANIF interface corresponding to the management VLAN on DeviceB.

  • If the double-tagged packets sent to the carrier network have the same outer VLAN tags as the S-VLAN tag, the packets can be transparently transmitted to DeviceB over the carrier network.

    Upon receipt of such a packet on its VLANIF interface, DeviceB compares the VLAN tag with the VLAN tag on the VLANIF interface. If the tags are the same, DeviceB removes the outer VLAN tag and then forwards the packet to the IP layer for processing.

  • The VLANIF interface on DeviceB adds an outer VLAN tag to received data packets. This tag is the same as the S-VLAN tag. The double-tagged packets can then be transparently transmitted to DeviceA over the carrier network. After receiving the packets, DeviceA removes the outer VLAN tag and then forwards the packets to local users.

Translation
Download
Updated: 2018-12-24

Document ID: EDOC1100038339

Views: 161749

Downloads: 688

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next