No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - Ethernet Switching

S1720, S2700, S5700, and S6720 V200R012(C00 and C20)

This document describes the configuration of Ethernet services, including configuring MAC address table, link aggregation, VLANs, VLAN aggregation, MUX VLAN, VLAN termination, Voice VLAN, VLAN mapping, QinQ, GVRP, VCMP, STP/RSTP/MSTP, VBST, SEP, RRPP, ERPS, LBDT, and Layer 2 protocol transparent transmission.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Closed Ring Networking

Closed Ring Networking

Closed ring-networking is at the aggregation layer and is used to aggregate Layer 2 unicast and multicast services. When SEP runs at the aggregation layer, redundancy protection switching can be implemented at the aggregation layer and the topology of the SEP segment can be displayed. On a closed ring network, two edge interfaces are located on the same edge device.

Figure 16-11 shows a networking diagram of a closed ring running SEP.

Figure 16-11  Closed ring running SEP

In Figure 16-11, LSW1 to LSW5 form a dual-homed link to access a Layer 2 network. LSW1 and LSW5 at the edge of the Layer 2 network are directly connected.

Translation
Download
Updated: 2018-12-24

Document ID: EDOC1100038339

Views: 155969

Downloads: 674

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next