No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - Ethernet Switching

S1720, S2700, S5700, and S6720 V200R012(C00 and C20)

This document describes the configuration of Ethernet services, including configuring MAC address table, link aggregation, VLANs, VLAN aggregation, MUX VLAN, VLAN termination, Voice VLAN, VLAN mapping, QinQ, GVRP, VCMP, STP/RSTP/MSTP, VBST, SEP, RRPP, ERPS, LBDT, and Layer 2 protocol transparent transmission.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Application of a Single Ring

Application of a Single Ring

To provide link backup and improve network reliability, you can construct a ring on the network.

Figure 17-20  Network of a single ring

In Figure 17-20, Transit 1, Transit 2, Transit 3, and Master constitute a single RRPP ring. Data traffic is transmitted along the path Transit 1 -> Transit 2 -> Master.

If RRPP detects a fault on the link between Transit 1 and Transit 2, Master unblocks its secondary interface and immediately instructs other nodes on the ring to re-learn MAC address entries and ARP entries. Traffic on the RRPP ring is then switched to the path Transit 1 -> Transit 3 -> Master.

Translation
Download
Updated: 2018-12-24

Document ID: EDOC1100038339

Views: 166059

Downloads: 695

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next