No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - Ethernet Switching

S1720, S2700, S5700, and S6720 V200R012(C00 and C20)

This document describes the configuration of Ethernet services, including configuring MAC address table, link aggregation, VLANs, VLAN aggregation, MUX VLAN, VLAN termination, Voice VLAN, VLAN mapping, QinQ, GVRP, VCMP, STP/RSTP/MSTP, VBST, SEP, RRPP, ERPS, LBDT, and Layer 2 protocol transparent transmission.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring Preferential Forwarding of Local Traffic in a Stack

Configuring Preferential Forwarding of Local Traffic in a Stack

Context

On a network where interfaces of multiple switches in a stack form an Eth-Trunk, configure the Eth-Trunk to preferentially forward local traffic to increase bandwidth use efficiency between stack devices and improve traffic forwarding efficiency.

Determine whether to enable preferential forwarding of local traffic on an Eth-Trunk based on actual needs:

  • If active interfaces in the local Eth-Trunk have sufficient bandwidth to forward traffic on the local device, enable this function to improve traffic forwarding efficiency and increase bandwidth use efficiency between stack devices.
  • If active interfaces in the local Eth-Trunk do not have sufficient bandwidth to forward traffic on the local device, disable this function to prevent packet loss. Some traffic on the local device is forwarded through member interfaces on another device.
NOTE:

The S1720GFR, S5700S-28P-LI-AC, and S5700S-52P-LI-AC do not support this configuration.

Pre-configuration Tasks

Before configuring preferential forwarding of local traffic in a stack, complete the following tasks:

  • Create an Eth-Trunk and add physical interfaces to the Eth-Trunk.

  • Establish a stack.

  • Ensure that member interfaces of the local Eth-Trunk have sufficient bandwidth to forward local traffic.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run interface eth-trunk trunk-id

    The view of the Eth-Trunk that needs to be configured to preferentially forward local traffic is displayed.

  3. Run local-preference enable

    The Eth-Trunk is configured to preferentially forward local traffic.

    By default, an Eth-Trunk forwards traffic preferentially through local member interfaces.

    NOTE:
    This function is only valid for known unicast packets, and is invalid for unknown unicast, broadcast, and multicast packets.

Translation
Download
Updated: 2018-12-24

Document ID: EDOC1100038339

Views: 167847

Downloads: 699

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next