No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - IP Service

S1720, S2700, S5700, and S6720 V200R012(C00 and C20)

This document describes the configurations of IP Service, including IP address, ARP, DHCP, DHCP policy VLAN, DNS, mDNS gateway, mDNS relay, UDP Helper, IP performance optimization, IPv6, DHCPv6, IPv6 DNS, IPv6 over IPv4 tunnel, and IPv4 over IPv6 tunnel.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring an ISATAP Tunnel

Configuring an ISATAP Tunnel

Context

When configuring an ISATAP tunnel, note the following points:

  • You must create a tunnel interface before setting tunnel parameters.

  • You are advised to set the tunnel number to be the same as the number of the source physical interface of the tunnel, when the specified tunnel source interface is a physical interface.

  • You need to configure an IPv6 address for the interface that connects a border device to the IPv6 network, and an IPv4 address for the interface that connects a border device to the IPv4 network. You also need to configure an ISATAP address with a 64-bit prefix-length as the IPv6 address of the tunnel interface to support a dynamic routing protocol.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run interface tunnel interface-number

    A tunnel interface is created.

  3. Run tunnel-protocol ipv6-ipv4 isatap

    The tunnel mode is set to ISATAP.

  4. Run eth-trunk trunk-id

    The interface is added to the Eth-Trunk.

  5. Run source { source-ip-address | interface-type interface-number }

    A source address or source interface is specified for the tunnel.

  6. Run ipv6 enable

    The IPv6 function is enabled on the interface.

  7. Run ipv6 address { ipv6-address prefix-length | ipv6-address/prefix-length } eui-64

    An IPv6 address is configured for the tunnel interface.

  8. Run undo ipv6 nd ra halt

    The device is enabled to send router advertisement (RA) packets.

Translation
Download
Updated: 2018-12-24

Document ID: EDOC1100038342

Views: 84745

Downloads: 281

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next